The MC10/100EP90 is a TRIPLE ECL TO LVPECL/PECL translator. The device receives differential LVECL or ECL signals and translates them to differential LVPECL or PECL output signals. A V
output is provided for interfacing with single ended LVECL or ECL signals at the input. If a single ended input is to be used the V
output should be connected to the D input. The active signal would then drive the D input. When used the V
output should be bypassed to ground by a 0.01 F capacitor. The V
output is designed to act as the switching reference for the EP90 under single ended input switching conditions, as a result this pin can only source/sink up to 0.5mA of current.
To accomplish the level translation the EP90 requires three power rails. The V
supply should be connected to the positive supply, and the V
connected to the negative supply.
The 100 Series contains temperature compensation.

• 260 ps Typical Propagation Delay
• Maximum Frequency > 3 GHz Typical
• Voltage Supplies V
• = 3.0 V to 5.5 V, V
• = -3.0 V to -5.5 V, GND = 0 V
• Open Input Default State
• Safety Clamp on Inputs
• Fully Differential Design
• Q Output will default LOW with inputs open or at V
• V
• Output
• These are Pb-Free Devices